To know how to install an office chair, first of all, we have to know what the parts of the office chair are so that we can know ourselves and each other. Now our most common office chair is composed of these parts: roller, five-claw, pneumatic rod, chassis, seat, armrest, backrest.
installation steps:
The first step is to check the number of parts before installation. Don't rush to install, it is easy to make mistakes. Generally, a pulley chair is a backrest + 1 seat + 2 armrests + 5 star feet + 5 pulleys + 1 pneumatic rod + 1 chassis! As many as possible, some are torx screws and some are other screws.
The second step is to install the pulley. Insert the wheel into the five-star foot, and use a little more force when inserting it (some of them are twisted into the thread)
The third step is to install the pneumatic rod. Put the pulley in reverse and put it back up. This step is the easiest.
The fourth step is to install the chassis. Place the cushion on the clean ground to install the chassis, pay attention to the direction of the chassis when installing, and tighten the screws
In the fifth step, after the chassis is installed, place the cushion on the gas rod and insert it into the hole of the chassis.
In the sixth step, after the cushion is placed on the air bar, the armrests are installed (note the front, back, left, and right of the armrests), and the screws are not too tight to facilitate the final installation of the backrest.
Step 7: Put the backrest on the seat cushion, pay attention to the direction, first align the backrest with the hole position of the armrest, and then install the screws on both sides of the bottom of the backrest. Also, do not tighten it. After installing the bottom screws, lift the backrest and install the top of the backrest. Screws, tighten all screws after installation.
The eighth step, after tightening all the screws, install the armrest decoration buckle, so that a complete chair is installed, you must try it to see if the chair is tight.
